Model 260 - Panel Mount Fluorescent Light Fixture

Fluorescent Lighting for Hazardous Locations

The 260/261 Series is a product designed specifically for Paint Spray Booths, with a wider fixture design these
products will provide increased photometric output and efficiencies. These 4 lamp 4' fixtures are available in
wattages including 32, 40, and 60 Watts. The 260 Series allows for both Front and Rear access using a paint
spray cutoff switch when the front door frame is opened. The 261 Series is a rear access only fixture and does
not require paint spray cutoff. Both units carry multiple listings from UL and ETL for Class I Div. 2 & Class II
Div. 2 applications. Must be mounted hinge side up.

LISTINGS:
ETL listed for U.S. and Canada
Class I Division 2 Groups A,B,C,D
T3C (160 degree C) Operating Code
Class II Division 2 Groups F,G
T3C (160 degree C) Operating Code
Listed for locations having deposits of readily combustible paint residues.

HOUSING:
20 Gauge steel construction with white baked enamel finish
which creates a durable, highly reflective finish.
Housing styles for either front and rear accessibility in the
Series 260, or rear access only in the Series 261.

LENS:
3/16" Clear tempered glass.

ELECTRICAL:
Paint spray cutoff switch for the front door frame access of the Series 260.
Available in 32, 40, and 60 Watts in T8, T8HLO, T12, & T12HO lamps.
Voltages of 120, 277, & 347 Volts.

APPLICATIONS:
Paint Spray Booths

OPTIONS:
All Options Ordered Separately
Panel Stiffner Kit #1704 (fits 18 gauge panels only)
EM: Emergency Battery Backup Ballast
120 or 277V MUST SPECIFY
Wire Whip 8 Ft. - 5901: 3-wire (261) or 5902: 5-wire (260)

NOTE:
Normally open magnetic switches are intended to be used to trigger a relay
(furnished by others) which disables the paint system. Because of the small
capacity of the switch a solid state relay is recommended. It may be desired
by others to utilize a separate power supply to segregate the relay
(furnished by others) from the lighting power supply.
The Magnetic Switch IS NOT designed to directly control light operation!
The Magnetic Switch is rated for 10 watts resistive at a maximum of 300 VAC.

CAUTION:
Overloading the switch circuits WILL cause failure.
LDPI, Inc. recommends having a certified electrician/engineer review
loads to ensure that overloading of switch does not occur.

SPECS

Back

Specifications/Options