400
- Fluorescent Slim Lights
SPECS
 
The Slim Light Series features a 20 Ga. baked white enamel steel housing that is only 2 1/4" thick maximizing
the available space allowed for your paint spray booth. The Slim Light Series is available in lengths of 3 & 4' with
2, 4 or 6 lamp options. The 3’ fixtures are available with T8 lamps. The 4’ fixtures are available with T5HO, T8, or
T8H.L.O. lamps. This series provides front door frame access with a paint spray cutoff switch when opened.
ETL listed in the U.S. and Canada, the Slim Light Series has multiple listings for inside access and wet
locations. Must be mounted hinge side up.
LISTINGS:
ETL listed for U.S. and Canada
Class I Division 2 Groups A,B,C,D
T3C (160 degree C) Operating Code
Class II Division 2 Groups F,G
T3C (160 degree C) Operating Code
(The Slim Light 420 & 440 in T8 are also UL listed for Class I Division 2 Groups A, B, C, & D.)
Listed for locations having deposits of readily combustible paint residues.
HOUSING:
20 Gauge steel construction with white baked enamel finish
which creates a durable, highly reflective finish.
The housing is a front access for convenient access, and the
2 1/4" depth maximizes the space needed for the paint spray booth.
LENS:
3/16" Clear tempered glass.
ELECTRICAL:
Paint spray cutoff switch in the front door frame.
Available in 3' / 25W T8 lamps, 4' / 32W T8, 54W T5HO, 32W T8HLO lamps.
Voltages of 120, 277 & 347 Volts. (347 Volt in 25 & 32 Watt products only)
APPLICATIONS:
Paint Spray Booths
OPTIONS:
All Options Ordered Separately
EM: Emergency Battery Backup Ballast
120 or 277V MUST SPECIFY
5902: 8 Ft. 5-wire whip
Corner/Hip Mount #4714 (Available for the 390440J-3546 fixture ONLY)
NOTE:
Normally open magnetic switches are intended to be used to trigger a relay (furnished by others)
which disables the paint system. Because of the small capacity of the switch a solid state relay
is recommended. It may be desired by others to utilize a separate power supply to segregate the
relay (furnished by others) from the lighting power supply. The Magnetic Switch IS NOT designed
to directly control light operation!
The Magnetic Switch is rated for 10 watts resistive at a maximum of 300 VAC.
CAUTION:
Overloading the switch circuits WILL cause failure. LDPI, Inc. recommends having a certified
electrician/engineer review loads to ensure that overloading of switch does not occur.
|
